11
Owner’s manual
EN
and connector cables in the following order: LED strip with
USB plug – connection piece – connector cable – connection
piece – LED strip. Connect the other LED strips in the same
manner. Make sure that all LED strips are similarly aligned
(all arrows are pointing in the same direction). Otherwise the
circuit will not be closed.
2. Cleaning the surfaces – In order for the LED strips to stick in
place, the surface they are stuck to must be smooth, dry and
free of dust, grease and dirt.
3. Sticking the LED strips in place – ATTENTION! When sticking the
LED strips in place, they mustn’t be connected to the mains supply!
Carefully remove the protective foil of a LED strip and stick it
on the desired area. Follow the same steps for the other LED
strips. Make sure that the USB cable is close enough to the
desired USB port!
4. Connecting to the device – Connect the USB cable to the USB
port of the desired device (television or similar). The backlight
is now ready for operation.
Changing the remote control battery
The battery for the remote control has already been inserted.
You only have to remove the transport guard.
1.
Pull out the battery compartment as shown on
the illustration.
2.
Remove the empty battery and insert a 3 V
battery, type CR2025. The positive terminal must
point upwards.
3.
Place the battery compartment back in the remote control so
that it locks in place.
Use
ATTENTION!
•
Do not look directly into the light source! Your eyes could be injured.
1.
Turn on the LED backlight by pushing the ON button on the remote control.
2. Select the desired color or the desired effect and push the
corresponding button on the remote control.
Please note that the color settings are mixed colors. For this
reason, the color tints may exhibit minor deviations. Even white
