Viper VR-6000, Owner'S Manual

Page: 20 / 76

INSTRUCTIONS MANUAL
MAINTENANCE
REPLACING REFRIGERANT FILTER/DRYER
The VIPER VR-6000 is equipped with two high side refrigerant filters/dryers and a low side
refrigerant filter/dryer (see figure 14). In order to maintain high qualityrecycled refrigerant:
•
The low side refrigerant filter/dryer must be changed when the VR-6000 displays the
service alarm [SERV] and the led “REPLACE FILTER” lights up.
NOTE: When recovering new refrigerant as when the machine is first placed in service
this alarm will light abnormally early and may be cleared by pressing the “SEL” key
while turning on the machine.
•
The high-pressure refrigerant filters/dryers must be replaced after approximately 30
hours of operation or 150 service jobs.
ATTENTION: Use only Clore Automotive Filters Part No. 315-032-000 (Low)
and Part No. 315-035-666 (High).
When changing the high pressure filters it is recommended that you disconnect the liquid
hose from the storage tank (close the hose valve and the liquid tank valve first), and recover
the refrigerant from the machine with another machine through the liquid hose. Then
proceed as described below:
2
3
1
Fig.14: Dryer filters
20