Viper FANG 32T-EU, User Manual

Page: 22 / 402

BETRİEBSANLEİTUNG
20
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Viper suggests to go near the walls with the right
side of the machine as shown.
CAUTION!
To avoid any damage to the floor surface, turn off the brush/pad-holder when the machine stops in one place,
especially when the extra pressure function is on.
SOLUTION FLOW ADJUSTMENT
Turn the solution switch (A) to “ON” position.
Adjust amount of solution flow by turning the solution control knob (B), turn left (counter-clockwise) for more solution,
or Turn right (clockwise) for less solution. The pin (C) is limit position of the solution control knob (B).
NOTE
Even if turn on the solution switch (A) ,the solution will not begin to flow until the operating triggers (D) are
pulled.
BATTERY DISCHARGE DURING OPERATION
Until the green warning light (3) stays on, the batteries allow the machine to work normally.
When the green warning light (3) turns off, and the yellow warning light (3) turns on, it is advisable to charge the batteries,
because the residual autonomy will last for a few minutes (depending on battery characteristics and work to be performed).
ENGLISH