Viper 350 Plus, Installation Manual

Page: 23 / 40

© 2008 Directed Electronics- All rights reserved.
23
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF:
When turned on, the doors will lock three seconds after the ignition is
turned on and unlock when the ignition is turned off. The 998T
Bitwriter will display separate steps for ignition lock and ignition unlock. They
can be programmed on or off independently.
1-4 ACTIVE/PASSIVE LOCKING:
If passive arming is selected in
step 1-1, then the system can be programmed to either lock the doors when
passive arming occurs, or only lock the doors when the system is armed via the
transmitter. Active locking means the system will not lock the doors when it
passively arms. Passive locking means that the system will lock the doors when
it passively arms.
NOTE: Remember, when passive arming is selected, the unit will chirp 20
seconds after the last door is closed. The system does not actually arm or lock
the doors until 30 seconds after the door has been closed.
1-5 PANIC WITH IGNITION ON:
This step controls whether or not
the Panic Mode is available with the ignition on. In some states, there are laws
prohibiting a siren from sounding in a moving vehicle. This feature makes the
system compliant with these regulations.
1-6 DOOR LOCK PULSE DURATION:
Some European vehicles,
such as Mercedes-Benz and Audi, require longer lock and unlock pulses to
operate the vacuum pump. Programming the system to provide 3.5 second
pulses, will accommodate the door lock interface in these vehicles. The default
setting is 0.8 second door lock pulses.
1-7 FORCED PASSIVE ARMING ON/OFF:
To use this feature,
passive arming must be selected in step 1-1. When turned on, forced passive
arming will ensure that the system will passively arm, even if a zone is left
open or invalid. Forced passive arming occurs one hour after the ignition is
turned off.