VIPColor VP7 Series, User Manual

Page: 44 / 90

44
Printer Maintenance
Guidelines for Preventive Maintenance
Recommended maintenance depends on the print mode that is most frequently
used. If you mostly print Roll to Roll (≥80%), refer to
Table 5 . Otherwise, see Table 6 .
Inspect means to check the condition and replace if necessary.
Note that these are general guidelines for preventive maintenance. As operating
conditions for your printer may differ, adjust your maintenance schedule
accordingly.
Table 5 Maintenance Schedule: For ≥80% Roll to Roll Operation
Part Every 1M inches
(25,400 m) Every 2.5M inches
(63,500 m) Every 5M inches
(122,500 m)
Sensors Clean – –
Cutter Assembly MM007‐64506 – Inspect Replace
Output Module VMAG1‐60008A – Inspect Replace
Service Station MM007‐65502 Inspect Replace –
Transfer Wiper Assembly
1
MM007‐65505 Inspect Replace –
Aerosol Fan Guard VMAG1‐70150A – Replace –
Waste Ink Absorber MM007‐10005 – – Inspect
Table 6 Maintenance Schedule: For ≥80% Roll to Cut/Print and Present Operation
Part Every 1M inches
(25,400 m) Every 2.5M inches
(63,500 m) Every 5M inches
(122,500 m)
Sensors Clean – –
Cutter Assembly MM007‐64506 Inspect – –
Output Module VMAG1‐60008A Inspect – –
Service Station MM007‐65502 Replace – –
Transfer Wiper Assembly
1
1. The transfer wiper assembly is part of the service station and may not be available as a separate replacement for
your printer. If it is not available, follow the maintenance schedule for the service station.
MM007‐65505 Replace – –
Aerosol Fan Guard VMAG1‐70150A – Replace –
Waste Ink Absorber MM007‐10005 – – Inspect