Chapter 2 Deployment Touch Panel
Manual VIPA HMI
2-2
HB160E - TP - RE_610-3B4I1 - Rev. 11/07
Installation
The Touch Panel is suitable for the installation in operating tables and
control cabinet fronts. The installation happens via the backside. The
Touch Panel is provided with a patented integrated fixing technique that
allows an easy connection with a simple screwdriver.
Due to the fact that the Touch Panel has a plug connector for bus
connection and voltage supply, a fast and easy device change is possible.
For the installation into a operating tableau and control cabinet fronts, the
Touch Panel requires the following front plate cutting:
W
H
Touch Panel
W x H in mm
610-3B4I1
287 x 217
The fixing technique is integrated in the casing of the Touch Panel and
accessible via the backside.
For the installation, a small slit screwdriver is required. Push the operator
panel [3] from the front side into the front panel cutting [1] until it touches
the panel with the seal [2]. Now bolt the lever [5] clockwise with the
screwdriver [4] until it rotates to the outside. Further screwing bolts the
lever to the front panel until it holds this to the control cabinet front.
1
2
3
4
5
Overview
Installation cutting
Installation
