Viozon ZB-3, Installation Instructions, Page: 2 / 2

Use screws and Screw Shim to connect the chassis to the pole.
4MM
INSTALL THE ACCESSORY TO THE MAIN POLE
INSTALL STAND BASE / POLE
As the picture shows,
use the hex wrench to
remove screws on
arm(β)
Place the microphone main stand at the inside hole of the parallel
connector, tighten the screw which is at behind of the parallel
connector. then put the microphone holder.
INSTALLING LAPTOP PLATE:
INSTALLING TABLET HOLDER:
Insert the Laptop Plate into the
groove, when heard a click
sound means done.
5MM
Remove the screws
from the adapter by the
hex wrench.
5MM
As the picture shows, put
the accessories at the
arm(α),tighten the screw.
If you want to get taller
height-using, you
could install the
extension rod between
the universal ball head
and the phone holder.
INSTALLING PHONE HOLDER:
Install the
universal ball
head at the
arm(β) at first,
then install the
phone holder.
a
Remove the screws
from the holder
adapter by the hex
wrench.
As the picture shows,
put the accessories at
the aparted arm, put
the screw back then
tighten it.
If you want to get taller
height-using, you could
install the extension rod
between the universal ball
head and the ring fill light.
INSTALLING RING FILL LIGHT:
Install the universal ball
head at the arm(β) at
first, then install the
ring fill light.
a
INSTALLING MICROPHONE HOLDER:
INSTALLING ADAPTOP:
5MM
Using the hex wrench remove the Screw(A) from the Parallel
Connector , place the Arm(β) inside, then tighten the Screw(A) .
As the picture shows,
put the
Clip Arm(α)
Clip Arm(β)
Parallel Connector into
the Pole
cover the
Post Cap
,
then, tighten the screw.
Clip
Arm(α)
Arm(β)
Arm(β)
Post Cap
Parallel Connector
Screw(A)
Scan QR code
get install video