STEP1. ATTACH MOUNT TO WORK SURFACE
CLAMP/GROMMET MOUNT
≥
0.6”
- ≤
2.36”
3.15”
2.36”
Install on open edge of
work surface:
For installation through a
grommet hole:
Slide the Base Stem against
work surface edge and fully
tighten clamp Screw(A).
Before inserting the Base
Stem,please detach the
Bottom Clamp(B) from the
Top Bracket(C) by loosening
Bracket Screws(A) with Hex
Wrench.
Then inserting the Base Stem
through grommet (dia.≥2.36”)
and against work surface
edge. Fully tighten Clamp
Screw.
A
A
C
B
a
STEP2. ATTACH ARM TO THE POLE
As the picture shows, install clip arm post cap in order.
The Clip could be adjusted on
your desired position by loosing
the screw(A), fix it.
HEIGHT ADJUSTMENT
Note: Please fix the inside nut of
post(B) in position before tighten
Screw(A) on the clip.
A
B
STEP3. ATTACH MONITOR TO ARM
As the picture shows,
install VESA mount on
monitor. Be careful to
leave the slide clip
upwards.
VESA standard:
75*75mm
;
100*100mm
Insert the VESA
connector into the
groove, when heard a
click sound means done.
A
Note: If you want to
remove the device,
please press shrapnel
(A) to remove the
device Up to extract.
Note: Open cable clip two sides.
Remove cable clip (A) from
the arm, thread cables, install
cable clip on the arm again.
A
STEP4. CABLE MANAGEMENT
Slide the plastic cover on the rear arm upwards until it
disengages. Put cables onto the plastic cover inside. Slide
the cover downwards until it click into place.
If you feel the pitching angle too tight or too loose when
adjusting the mount, please adjust the Screw.
TENSION ADJUSTMENT
6MM
5MM
5MM
ARM ADJUSTMENTS
