14
THE ANALOG OUTPUTS
are situated on the rear panel, fitted with electronically balanced XLR
terminals, as well as RCA sockets.
Both outputs may be used simultaneously !!
Polarity of the XLR terminals complies with AES 14-1992:
1 = ground, 2 = (+) in phase, 3 = (-) out of phase.
Source impedance of all analog outputs is significantly lower than
1 (one) Ohm !
NOTE:
When connecting unbalanced lines to the balanced outputs, pin 3 must
not be bridged but left unused (open). In this case the resulting output
level will be 6 dB less.
NOTE:
The
“special settings” menu will enable “phase reversed” analog outputs
instead of in-phase outputs if required. The phase shift is relative to the
incoming digital audio data and is no channel shifting by means
of L > R / R > L !!
THE POWER SWITCH
The unit is activated by means of the power switch. Power-on status is
indicated by the blue LED below.
