User's Manual
Arctic GPRS Gateway
Firmware Version 5.0.7
18
Document Version 1.6
3 Getting Started
3.1
Unpacking the Arctic
Arctic is delivered in a bulk package containing only the device itself.
A separate Arctic Accessory Kit (ordered separately) contains the following
items:
■
Power supply and cable
■
Cross-over Ethernet Cable
■
Null modem cable
If any of the items are missing or damaged, please contact Viola Systems Ltd.
All packaging materials are recyclable. Viola Systems urges its customers to
follow environmental regulations regarding the disposal of all the materials.
3.2
Installation of the Arctic
The Arctic can be installed horizontally on a flat surface e.g. on a desk or a
rack.
When installing Arctic models with wireless connectivity options, it should be
remembered that high-frequency radio waves need to be taken into account.
The surrounding environment affects the range of radio signals. Therefore,
if you are using an Arctic with antennas directly mounted to the antenna
connector, try to avoid placing the Arctic where the radio signal might be
disturbed (“shadowed”) by nearby obstacles. Also large metallic surfaces
(racks) may have a highly detrimental effect on the antenna performance. In
case of metal racks or surfaces, it is recommended to use an external antenna
with an appropriately selected cable. By following these precautions, the Arctic
may be installed more freely.
The aluminum case of the Arctic contains rails for wall mounting. Both broad
sides contain two rails and the narrow side opposite to the LED panel contains
one rail. These rails allow a flexible selection of the optimum mounting
direction. To mount the Arctic on a wall using optionally available mounting
tools can be used.
3.3
Setting of the IP Address Using an HTML Browser
This is the recommendable way to set up the network parameters. It is
an easy-to-apply solution if the computer used for configuration has been
properly configured. Follow the procedure listed below:
