48
VIO-S218
Cod. 420120267 REV. 0.1
STACKED INSTALLATION
•
For safety reasons, a maximum of 3 modules can be assembled in stacked configuration
on DRK-212 fly-bar.
•
Use DBTECHNOLOGIES COMPOSER to set project parameters.
•
Position DRK-212 fly-bar (step A) on SUB 218 (installed on a flat surface). For further
details on this accessory, refer to the complete manual.
•
Add VIO-L212 modules one by one, with the previously-calculated angle, as shown in
MECHANICS paragraph.
•
Make sure that the local parameters of the different modules and subwoofers are
correctly set on the single amplifier panels. As an alternative, all parameters can be
remotely edited in real time or at a later stage in case of line-array connection through
the RDNet network (AURORA NET). Nevertheless, project initial settings should at
least be physically repeated on the VIO-L210 modules before installation. For further
informations please see
CONFIGURATION PARAMETERS
section.
• Make the audio daisy-chain, RDNet and power connections as described in previous
paragraphs.
English
