VINYL WORKS CANADA CS Manual Download Page 8

FOR COMPLETE WARRANTY INFORMATION PLEASE VISIT OUR WEBSITE OR CALL OUR CUSTOMER SERVICE 

DEPARTMENT AT TOLL FREE 877-VINYL WK  -  

( PLEASE RETAIN ORIGINAL PROOF OF PURCHASE ) 

……………………………………………………………………………………………………………………………………….......

 

VINYL WORKS CANADA – 5 YEAR WARRANTY - PRODUCT REGISTRATION 

 

Register online at www.vinylworkscanada.com or return completed warranty registration to: 

Vinyl Works Canada – PO Box 96, Port Colborne, Ontario, Canada L3K5V7 

( If mailing from USA international postage is required ) 

 
Owner’s name: _________________________________________        Purchase date: ______________________ (yy/mm/dd) 
 
Address: ____________________________________________________________________  Phone #: ____________________ 
 
Pool make: ____________________   Pool size: _________   Pool height: _________   Retailer: ________________________ 
 
Retailer’s address: _________________________________________________________________________________________ 
 
Product purchased (+VWC model #): ________________________________________   Product Color: ________________ 

Check out our entire 

product line at 

www.vinylworkscanada.com 

 

Thank you for purchasing 

our product - please enjoy 

& remember, SWIM SAFELY  

NOTHING REPLACES

NOTHING REPLACES

NOTHING REPLACES

NOTHING REPLACES    

PARENTAL SUPERVISION

PARENTAL SUPERVISION

PARENTAL SUPERVISION

PARENTAL SUPERVISION    

Recycle Responsibly 

www.vinylworkscanada.com  

877-VINYL WK 

Figure 14 

Figure 15.3 

Figure 15.2 

# 14 - CHECK STRINGERS 

Before  positioning  step  system  in 
the  pool  check  the  bottom  of  the 
stringers  of  the  in-pool  portion  to 
make  certain  there  are  no  sharp 
edges  or  debris  attached.  It  is 
VERY IMPORTANT that the bottoms 
of the stringers be smooth as not to 
damage the pool liner. It is HIGHLY 
RECOMMENDED  to  use  a  step  /  
ladder  pad  beneath  the  stringers 
inside the pool (sold separately) 

Check bottom of stringers 

# 15 - POSITION IN POOL 

Determine  the  desired  location  of  the  step  system  in  the  pool.  It  is          
recommended  to  be  easily  accessible  but  not  in  a  high  traffic  location. 
The step system must be placed between two of the pool upright support 
posts (Figure 15.1 & 15.2). Lower the step into the pool making certain the 
in-pool  portion  fills  with  water  and  sits  level  and  stable  on  the  pool  floor. 
The  exterior  portion  should  be  leveled  with  the  in-pool  portion.  Make     
certain the step system sits on a solid, level base before using. Review all 
safety  instructions  and  proper  use  before  using  entry  system.  Keep  step 
system free of any obstructions - NEVER attach items to the top platorm, 
treads  or  support  posts  as  they  may  cause  entrapment.  Test  gate  for 
proper  operation.  Make  certain  it  opens  under  tension,  self-closes  and 
securely latches. When pool is not in use make certain the gate is locked 
at  all  times  (Figure  15.3  -  LOCK  NOT  INCLUDED).  REMEMBER  -               
ABSOLUTELY  NO  DIVING  OR  JUMPING  FROM  STEP  ENTRY  SYSTEM  - 
THE  POOL  HAS  SHALLOW  WATER  AND  SERIOUS  PERSONAL  INJURY 
CAN OCCUR. NEVER SWIM ALONE - SWIM SAFELY AT ALL TIMES 

Summary of Contents for CS









Reviews: