97
Assembly - earlier clamps
13
Install the bottom clamp as follows:
13.1 Apply white bearing grease to the cam surface of the cam moulding
and the washer
.
and the lower clamp
assembly
in the bottom clamp moulding
.
14
Install the oval leg as follows:
14.1 Working from the rear, insert the oval leg in the bottom clamp moulding
, taking care not to
damage the surface of the lower clamp assembly
.
14.2 Push the leg down until the T-piece
is at about the midway position. Flex the leg tubes
outwards and engage the T-piece
with the legs.
14.3 Refit the foot
on the oval leg tube
and secure with the screw
15
Install the clamp knob as follows:
15.1 Position the clamp knob
on the bottom clamp shaft
and turn the knob counter-clockwise
to the ‘OFF’ position.
15.2 Install the grubscrew
in the bottom clamp shaft
.
16
Adjust the clamp.
See “Adjusting ‘Pozi-Loc’ leg clamps” on page 89.
NOTE:
On M5 bottom clamps, the grubscrews
are identical (M5 x 5 mm).
Summary of Contents for Vision Pozi-Loc
Page 1: ...Contents Vinten Camera Control Solutions Next Page Previous View Vision Pozi Loc Tripods ...
Page 8: ...8 Contents Previous Page First Page Next Page Previous View Part 1 Illustrated Parts Lists ...
Page 85: ...85 Contents Previous Page First Page Next Page Previous View Part 2 Repairs ...