96
Assembly - current clamps
6
Install the bottom clamp as follows:
6.1
Apply white bearing grease to the cam surface of the cam moulding
and the washer
.
6.2
, the cam moulding
and the lower clamp
assembly
in the bottom clamp moulding
.
7
Install the oval leg as follows:
7.1
Working from the rear, insert the oval leg in the bottom clamp moulding
, taking care not to
damage the surface of the lower clamp assembly
.
7.2
Push the leg down until the T-piece
is at about the midway position. Flex the leg tubes
outwards and engage the T-piece
with the legs.
7.3
Refit the foot
on the oval leg tube
and secure with the screw
8
Install the clamp knob as follows:
8.1
Position the clamp knob
on the bottom clamp shaft
and turn the knob counter-clockwise to
the ‘OFF’ position
8.2
Install the grubscrew
in the bottom clamp shaft
9
Adjust the clamp.
See “Adjusting ‘Pozi-Loc’ leg clamps” on page 89.
Dismantling - earlier clamps
10
Remove the clamp knob as follows:
counter-clockwise to the ‘OFF’ position.
10.2 Using a suitable instrument, such as a flat-bladed screwdriver, carefully remove the knob cap
10.3 Remove the screw
and clamp knob
.
10.4 Remove the locking grubscrew
and grubscrew
11
Remove the oval leg as follows:
11.1 Remove the screw
to the oval leg tube
11.2 Slide the leg upwards until the T-piece
is at about the midway position.
11.3 Flex the leg tubes
outwards and disengage the T-piece
towards the rear. Pull the oval
leg backwards and upwards out of the bottom clamp.
12
Remove the bottom clamp as follows:
12.1 Remove the lower clamp assembly
, the cam moulding
, the bottom clamp shaft
and
the washer
from the bottom clamp moulding
Summary of Contents for Vision Pozi-Loc
Page 1: ...Contents Vinten Camera Control Solutions Next Page Previous View Vision Pozi Loc Tripods ...
Page 8: ...8 Contents Previous Page First Page Next Page Previous View Part 1 Illustrated Parts Lists ...
Page 85: ...85 Contents Previous Page First Page Next Page Previous View Part 2 Repairs ...