25
14.3 On the underside of the head, remove three screws
securing cover plate
.
14.4 Operate the pan brake lever
from the OFF to the ON position.
14.5 If brake pressure is not felt after approximately one-third of the lever travel, turn the locating pin
clockwise until this is achieved.
14.6 Operate the pan brake lever
to the OFF position and ensure that the head is free to rotate.
14.7 Refit cover plate
Repositioning the wedge adaptor
15
The wedge adaptor is secured by four cap head screws which pass through the wedge adaptor into the
sliding plate.
WARNING!: Over-long screws will prevent the sliding plate from operating. Always use
the screws provided (M6 x 30mm).
Fig 4.5 Repositioning the wedge adaptor
(1)
(4)
(2)
(3)
V700 RIT