Vinten Protouch PRO-6 HDV, Operator'S Manual

Page: 26 / 29

Back
26
‘Pozi-Loc’ tripod leg clamp adjustment
Bedding-in occurs with ‘Pozi-Loc’ leg clamps, which may necessitate resetting the clamp. Check
the effectiveness of each leg clamp and adjust as follows:
Top clamp
Turn the clamp knob (21) to the vertical, ‘off’ position
Remove screw (21.1) . Using a suitable peg spanner, back off the threaded insert (21.2) slot by
slot until the leg is free to move under its own weight.
While sliding the leg in and out, gradually tighten the threaded insert (21.2) until the clamp begins
to grip.
If not aligned, back off the threaded insert (21.2) until a slot aligns with the hole for screw (21.1) .
Back off the threaded insert (21.2) a further three slots
Install screw (21.1) to secure the threaded insert (21.2) .
Fig 9 Top clamp adjustment
(21.1)
(21.2) (21)