10
Installation
4
3
4
6
6
4
1.
Ensure that the rubber straps on each foot support (6) are to the
outside of the ball joint.
2.
Fully slacken the skid clamp (1).
3.
Ensure the control valve (2) is set to the WORK position.
4.
Release the Velcro retaining strap (3).
5.
Hold the column upright and release the Velcro retaining strap (3)
holding the three struts. Raise the struts (4) to about 30° from the
horizontal. The strut joints are adjusted to retain the struts in this
position
6.
Lift the column assembly by the steering ring and lower it vertically
into the skid centre casting, ensuring skid clamp (1) is aligned with
fixed leg on the skid (see marking on skid for correct orientation
), at the same time engaging the struts (4) on the foot supports (6).
7.
Secure each strut to the foot support with the rubber strap.
8.
Tighten the skid clamp (1), using moderate hand pressure only. The
clamp lever has a spring loaded ratchet-type action and is operated
as follows:
9.
Turn the clamp lever clockwise as far as possible.
10.
Pull the lever outward against the spring pressure, return it to
vertical and release.
11.
Turn lever clockwise again.
12.
Repeat until the skid clamp is sufficiently tightened.
13.
Secure the Velcro retaining strap (3) clear of the skid wheels.
Column
Install the column on the skid as follows:
Summary of Contents for OSPREY lite
