Improper use of the grounding plug can result in the risk
of electric shock. Consult a qualified electrician or service
person if the grounding instructions are not completely
understood. If the supply cord is damaged, it must be
replace by a qualified person in order to avoid electrical
hazard.
INSTALLING YOUR Wine Cellar
Unpack and remove all of the protection and adhesive
strips from the packaging around and inside the Wine
Cellar. The Wine Cellar must be positioned such that
the plug is accessible. Release the power cord.
Move your Wine Cellar to its final location. The Wine
Cellar should be installed in a suitable place where the
compressor will not be subject to physical contact.
Leveling your Wine Cellar :
Wine Cellar must be leveled
BEFORE loading your wines.
Your Vintec Wine Cellar is equipped with 4 adjustable
feet to facilitate easy leveling.
VINTEC
recommends that you tighten the back feet to
the maximum and adjust the front feet to level of the
Wine Cellar .
VWS035SSA-X/VWS035TBA-X
VWS048SCA-X
OPERATION ANOMALIES
Ensure that there is power to the electrical supply
plug by connecting another electrical appliance to
it. Check fuse, if any. Make sure that the door is
closed properly.
If your Wine Cellar appears to be malfunctioning,
unplug it and contact your VINTEC’s aftersales
service.
Any intervention on the cold circuit should be
performed by a refrigeration technician who
should carry out an inspection of the circuit sealing
system. Similarly, any intervention on the electrical
circuit should be performed by a qualified electrician.
DOOR REVERSAL
#1. Open the door to a 90 degree angle, take
out the 2 screws from door axis , remove
the door , Remove the Door axis .
#2. Unscrew the screw located underneath
the door frame and the limit device, and
relocate it at left the end side of the door
frame.
#3. Take out the 3 hinge screws from the top
hinge (right)and remove it.
#4. Remove decorative nail from left top of
cabinet and install spare top hinge (Left)
at left top of cabinet with 3 screws.
#5. Overturned the lower hinge. Install the
lower hinge at left lower of the cabinet
with 3 screws(5).
- The door axis revolves 180 degree, Put it
into the door axis hole of the door.
#6.Install and aligne the door. Screw down
the 2 screws(1).
#7. Insert the plastic caps to cover the holes.
#1. Unscrew and remove the decorative cover.
While holding the door firmly, loosen and
remove the top hinge, lift up and remove
the door .
#2. Unscrew the lower hinge .
#3.-Remove the long cabinet leg on the left
side, and shift it to the right end side.
- Install the lower hinge and tie it with the
bolts.
- Install the door on the axis of lower hinge
the same way it was removed, screw back
the top hinge on the right.
#4. Fix back the decorative cover and rubber cover.
#1. Unscrew and remove the decorative cover.
While holding the door firmly, loosen and
remove the top hinge, lift up and remove
the door.
#2. Unscrew the lower hinge .
#3.- Install the lower hinge and tie it with the
bolts.
- Install the door on the axis of lower hinge
#4.- the same way it was removed, screw back
the top hinge on the right
- Fix back the decorative cover and rubber
cover.
9
User Manual
