background image

2

GB

Thank you for purchasing your new wine 

cooler from Vintec. Please note that these 

instructions apply to all wine coolers in 

the Vintec range. Illustrations and fi ttings 

may therefore not necessarily correspond 

exactly to your model.

Warning

As the refrigerant used in this appliance is a 

fl ammable gas (Isobutane R600a), special 

care must be taken to prevent damage 

to the refrigerant circuit and piping during 

transport and installation.

If damage does occur, avoid sparks or 

naked fl ame in the vicinity of the appliance, 

ensure that the room is well ventilated, 

disconnect the power supply, and contact 

your supplier.

The unit must only be serviced by quali-

fi ed technicians from an approved service 

centre.

Old appliances

Old refrigerators and freezers are often 

fi tted with complicated latches that can 

only be opened from the outside. If you 

have one of these old units stored away 

somewhere, or if you scrap one, remember 

to destroy the latch fi rst in order to prevent 

children from being exposed to great dan-

ger by getting locked inside the unit. 

Disposal

This appliance contains recyclable materi-

als. Before disposing of the unit, detach the 

plug from the cable and remove the door. 

If the door is left on, the appliance is highly 

dangerous for children at play.

Environmental regulations on disposal must 

also be observed. When disposing of the 

appliance you should contact your local au-

thority technical department who will inform 

you of how collection and recycling of such 

units take place in your area.

Before use

Before operating your new appliance, 

please read the following instructions care-

fully as they contain important information 

on safety, installation, operation and main-

tenance. Keep the instructions for future 

reference.

On receipt, check to ensure that the ap-

pliance has not been damaged during 

transport. Transport damage should be 

reported to the local distributor before the 

wine cooler is put to use.

Remove the packaging. Clean the inside of 

the cabinet using warm water with a mild 

detergent. Rinse with clean water and dry 

thoroughly (see cleaning instructions). Use 

a soft cloth.

If during transport the appliance has been 

laid down, or if it has been stored in cold 

surroundings (colder than +5°C), it must be 

allowed to stabilise in an upright position for 

at least an hour before being switched on.

Contents

Get to know your wine cooler...........3

Installation and start-up....................4

Reversible door.................................7

Electrical connection.........................8

Operation and function.....................9

Defrosting,

cleaning and maintenance..............11

Fault fi nding....................................12

Summary of Contents for V 150 SG2E













Reviews: