Vino Series Flex
Installation Instructions for Vino Series Flex (VP-FLEX and VR-FLEX)
• (2) Mounting Strips (unique
neck and base for Vino Pins)
• (6) mounting hole caps
Parts List
Important Note:
These installation instructions are only for attaching the Vino Series Flex (for Pins or Rails)
mounting system into solid wood, plywood surface, or drywall with a minimum thickness of 1/2” (12.7mm).
Figure A
Figure B
1. Identify the Pieces
First, identify the face of the mounting strip, which has more
1/4” holes than 1/2” holes. Then, identify the top of each Mount-
ing Strip by noting the end with 1/2” diameter mounting holes
closest to the top. Finally, if installing Vino Pins Flex, identify
the neck side of the Strip, which has the higher of the assembly
(1/4” diameter) holes.
• (2) Plastic couplers
• (4) spiral drywall anchors
• (6) screws
• (2) toggle bolts
• (18) Vino Series screws
• Phillips head screwdriver
• Level
• Pencil
• Tape measure
Required Tools
• Drill
• 1/2” Drill bit (spade)
• 1/16” Drill bit
• Protractor or adjustable level
for angled installs
For racking itself, the Vino Pins (racks) neck side features a
narrower divot than the base side.
2. Assemble Pins/Rails to Strip
Insert one Vino Series screw through the back of either the
Base or Neck strip and thread the first Vino Pin or Rail until
tight against the surface of the strip. Repeat until all Pins or
Rails are attached.
3. Choose Bottle Direction (Pins)
Decide if you want the necks of the bottles facing left or
right then identify the neck strip.
Vino
Pins
Vino Rails
• Vino Pins or Vino Rails
(may be sold separately)
Required Parts
