16
www.vintageair.com
905460 REV D 01/12/17, PG 16 OF 28
Evaporator Installation (Final)
1.
2.
With the louver bezel mounted and the dash bracket secured to the evaporator, drill a 7/32” hole aligned with
the center of the slot on the dash bracket. Drill through the OEM dash brace, the bottom of the dash and the
top of the louver bezel. Attach the dash bracket to the dash through all drilled holes using a 10-32 x 1” pan
head screw, (2) 3/16” flat washers, and a 10-32 nut with star washer (See Photo 35, below). NOTE: Install
this screw upward from the louver bezel.
Check that the evaporator unit is level at the passenger side of the drain pan (See Photo 36, below). If the unit
is not level, check to ensure installation steps were properly performed.
Photo 35
Photo 36
10-32 x 1”
Pan Head Screw,
(2) 3/16” Flat Washers,
and 10-32 Nut with
Star Washer
Drill 7/32”
Hole
