Vinotemp VT-DSIDM-R, Manual

Page: 13 / 21

OPERATING INSTRUCTIONS
CONTROLS OF THE ICE MAKER
Control Type Condition Function Explanation CHECKING THE
WATER SUPPLY
Button Press To turn the Ice Maker on/off,
press and hold this button
for approximately 3 seconds.
1. Turn off water supply.
2. Disconnect line from the ice
maker.
3. Position water supply line in
a bucket.
4. Turn on water and make
sure water falls into bucket.
5. Before reconnecting the
water supply line to the ice
maker, make sure the
water is turned off, then
reconnect the water supply
line to the ice maker.
If unsure, please contact
your local plumber.
①
“Water tank is full.”
a. Unscrew the drain cap (12)
located on the back of the
unit and let out the water.
(Refer to Page 5, Fig. B.)
Button Press Small size of ice
Button Press Medium size of ice
Button Press Large size of ice
Indicator Light ON Small size of ice is selected.
FLASHING
Water tank is full.
①
Indicator Light ON Medium size of ice is selected.
Indicator Light ON Large size of ice is selected.
FLASHING Ice bin is full of ice.
④
Indicator Light ON Compressor is working.
OFF Compressor stopped working.
FLASHING Stand by condition.
Indicator Light
Flashing at the
same time.
Ice maker low on water.
②
Indicator Light Flashing at the
same time.
Sensor breakdown
③
b. After draining out all the water from the outside water tank, reconnect unit to power and it will continue to run normally.
c. If “Drain pump mode” is chosen, please confirm the “Pumped water outlet switch” is in the“ON” position. If it is in the
correct position but you still get a WARNING ALARM after you power off the unit, please contact a service center
.
d. If “Manual drainage system mode” is chosen, the outside water tank will be full of water within one or two weeks
depending on differences in ambient temperatures, please drain the water.
②
“Ice maker low on water”
a. Check if outside water supply is functioning normally. Please see “Checking the water supply” box above.
b. The icemaker will remove faults automatically within 30 minutes and work normally when outside water pipe is functioning.
c. Press “ ” button and turn on the unit again if icemaker does not function normally after 30 minutes;
d. If the icemaker still shows a WARNING ALARM after the above process is repeated, contact the service center.
③
“Sensor breakdown”
Please contact our authorized service center.
④
“Bucket full” alarm:
a. Check if the ice bucket is full. If so, remove the ice, and the alarm will stop.
b. If the ice bucket is not full when the alarm sounds, check to see if the ice maker cover plate is stuck. Clear any obstruction and
replace the cover. The alarm should stop.
c. When there is an insufficient water supply, the ice maker cover plate may stick and the “bucket full” alarm will sound. Remove any
ice from around the cover plate and check that the water supply is sufficient. The alarm should stop.
10