8
8
W W W . V I N O T E M P . C O M
INSTALLATION
Remove all packing material before using your wine cooler. Check to be sure all parts are
included and that the cooler is in good condition.
IMPORTANT
: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water and a soft cloth.
This unit is designed for freestanding installation and indoor use only. Position the unit in a dry
and well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in
direct sunlight. Do NOT install the unit in a location with an ambient temperature that will fall
below 50°F.
When positioning the cooler, 6 inches of space at the back and 10-12 inches of space both sides
are suggested to ensure proper air circulation to cool the cooling system. There also must be
unlimited clearance at the top of the cooler to ensure proper air circulation.
The unit is designed for freestanding installation only. It is not designed to be installed under a
counter, inside a cabinet, or in any location that does not allow the proper clearances on all sides,
as stated above.
Place the wine cooler on a solid, level surface strong enough to support it when it is fully loaded.
To level the wine cooler, adjust the front leveling legs at the bottom of the wine cooler. To
ensure vibration and noise-free operation, do not install on carpet.
For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 50°-80°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
Upon plugging the cooler into an electrical outlet, let the unit run for at least 30 minutes before
making any adjustments.
OPERATING YOUR WINE COOLER
The wine cooler has an electric temperature control panel and two temperature zones. When first
turned on, the LED display will show the ambient temperature, followed by the internal cabinet
temperature.
UP
Used to raise (warm) the corresponding zone set temperature by 1°C or 1ºF.
DOWN
Used to lower (cool) the corresponding zone set temperature by 1°C or 1ºF.
ºF/ºC
Selector
Used to select the temperature display setting in degrees Fahrenheit or degrees Celsius. To change
the temperature from Fahrenheit to Celsius or from Celsius to Fahrenheit, touch this button.
CONTROL PANEL LOCK
Used to lock or unlock the control panel.
