INSTALLATION INSTRUCTIONS
Before Using Your Wine Cellar:
•
Remove any exterior and interior packing material.
•
Check to be sure the following parts are included:
o
For 16 Bottle Wine Cellar, 3 slide out shelves.
o
1 instruction manual.
•
Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
•
Place your appliance on a surface that is strong enough to support the appliance when
it is fully loaded.
•
To level your appliance, adjust the front legs at the bottom of the appliance.
•
When positioning the cooler, leave a minimum of 6 inches at the back of the cooler,
10-12 inches on each side of the cooler. There must be unlimited clearance at the top
of the cooler. This will ensure proper air circulation.
•
The unit is designed for freestanding installation only. It is not designed to be installed
under a counter, inside a cabinet, or in any location that does not allow the proper
clearances on all sides, as stated above.
•
Locate the cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Several inches clearance is required at rear for proper
air circulation.
•
Clean the interior surface with lukewarm water using a soft cloth.
OPERATING YOUR WINE CELLAR
It is recommended that you install the wine cellar in a place where the ambient
temperature is between 50-80°F. If the ambient temperature is above or below
recommended temperature, the performance of the unit may be affected. Placing in
extreme cold or hot conditions may cause interior temperature to fluctuate. The range of
54-66°F may not be reached. Not intended for garage or basement installs. The
temperature may fluctuate depending on whether or not the interior light is on or off or
whether the bottles are located on the upper/middle or lower section. Close the cellar door
immediately after putting in any items so the inside temperature will not rise dramatically.
How to use the buttons on the Display Panel:
You can set the temperature by pushing the control buttons.
There are two buttons on the panel “ + ” and “ - ” to adjust the temperature by 1°F
increments from 54-66°F. You can turn the interior light on or off by pressing the light
button.
8
