8
W W W . V I N O T E M P . C O M
INSTALLATION I
IONS
Before using your wine cellar:
•
Remove all packing mater
•
Check to be sure the follo
o
For VT-12TEDS, 3 Slide out shelves
o
1 instruction manual
•
Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth before first use.
•
Position the cooler in a dry and well ventilated place. The recommended ambient
temperature should be between 50°F and 80°F.
•
Place your cooler on a solid, level surface (other than carpet). This will ensure vibration
and noise-free operation.
•
When positioning the cooler, leave a minimum of 6 inches at the back of the cooler, 10-
12 inches on each side of the cooler. This will ensure proper air circulation.
•
The unit is designed for freestanding installation only. It is not designed to be installed
under a counter, inside a cabinet, or in any location that does not allow the proper
clearances on all sides, as stated above.
•
Upon plugging the cooler into an electrical outlet, let the unit run for at least 30 m utes
before making
•
This wine coole
ssor) and is not
designed for storage in hot areas like gara
of 30 degrees below the ambient temperature.
NE COOLER
ure
ed
of 50-
not the
e
You
NSTRUCT
ial before using your cooler.
wing parts are included:
in
any adjustments.
r uses thermoelectric refrigeration technology (no compre
ges, warehouses or outdoors since it is
designed to operate at a maximum
OPERATING YOUR WI
It is recommended that you install the wine cellar in a place where the ambient temperat
is between 50°F and 80°F. If the ambient temperature is above or below recommend
mperature, the performance of the unit may be
te
affected. For example, placing in extreme
cold or hot conditions may cause interior temperature to fluctuate. Internal range
66°F may not be reached. The temperature may fluctuate depending on whether or
terior light is on or off or whether the bottles are
in
located on the upper, middle or lower
section.
How to use the buttons on the Display Panel:
You can set the temperature as your desire by pressing the control panel buttons. There ar
two buttons on the panel “ ” and “ ” to adjust the temperature by 1°F between 50-66°F.
can turn the interior light on or off by pressing the light button.