1
0
10
W W W . V I N O T E M P . C O M
TEMPERATURE ZONES
The wine cooler has two temperature zones with a temperature range of 40°-72°F. The recommended
temperature setting for each zone is:
Lower Zone
between 55°-72°F (Ideal for red and white wines)
Upper Zone
between 40°-55°F (Ideal for sparkling and white wines)
NOTE: The temperature set for the Lower Zone must always be the same or higher than the
temperature set for the Upper Zone. For optimal performance, the set temperature of the two
zones should differ by at least 4°F.
SETTING A TEMPERATURE
Touch
SET
to set the internal temperature for each zone. The degree indicators will appear in the
display window marked
for UPPER ZONE and
for LOWER ZONE.
When you touch
SET
for the first time, the LED readouts will show the original temperature settings
(preset factory setting for UPPER ZONE is 50ºF / 10ºC and for LOWER ZONE is 60ºF / 16ºC).
Touch
SET
once. The left LED indicator for UPPER ZONE will flash. Then touch
UP
or
DOWN
to set the desired temperature.
When you touch
SET
again, the right LED indicator for LOWER ZONE will flash. Then proceed to
touch the
UP
or
DOWN
to set the desired temperature for the LOWER ZONE.
The temperature will increase by 1°C or 1ºF if you touch
UP
once, or the temperature will decrease
by 1°C or 1ºF if you touch
DOWN
once.
To view the set temperature in either zone at any time, touch
UP
or
DOWN
and the set
temperature will temporarily flash in the LED display for 5 seconds. You can touch
SET
to view the
temperature setting from one zone to the second zone.
NOTE
: When using the unit for the first time or after a long period of inactivity, there may be a variance of
a few degrees between the selected temperature and the temperature indicated on the LED readout.
This is normal due to the length of inactivity, and will correct itself after the unit runs for a few hours. If the
unit is unplugged, has lost power or is turned off, wait 3 to 5 minutes before restarting the unit. The unit
will not restart before this time delay.
DYNAMIC COOLING/SILENT MODES
The Dynamic Cooling feature enables the relative humidity inside the unit and the temperature to be
distributed evenly around the interior so you can store all of your wine under the exact same excellent
conditions. If you would like to use the unit to store wine long term, the dynamic cooling is a must. This
will create a continuous climate in the cabinet which imitates that of a wine cellar.
In the Dynamic cooling mode, the interior fan circulates the inside air evenly until the set temperature is
reached. Dynamic Cooling is the factory preset mode. To change to Silent mode, touch and hold the
UP
button for approximately five seconds. The wine cooler will beep three times to confirm silent mode is on.
To change back to Dynamic Cooling mode, touch and hold the
DOWN
button for five seconds. The wine
cooler will beep five times to confirm Dynamic Cooling mode is on.
