7.8 REPLACING THE EVAPORATOR FAN MOTOR, TEMPERATURE SENSOR AND PTC HEATER
FOR SINGLE ZONE MODELS
1. Remove all shelves.
2. Remove the screws
○
2 that secure the air channel cover
○
1 to the cabinet.
3. Disconnect the evaporator fan motor wires. Then pull out the air channel cover.
4. Unscrew the thermistor supporter
○
4 and now you can replace the temperature sensor
○
3 .
5. Now you can see the PTC heater
○
8 and evaporator
○
9 and then you can replace them.
6. Remove the fours screws
○
5
that secure the fan motor F1C
○
7
to the air channel cover
and then you can replace the evaporator fan motor.
1
2
3
4
7
9
8
5
6
7.9 EPLACING THE CONDENSER FAN MOTOR
1. Disconnect the condenser fan motor lead connector from the cable or power PCB inside the
electrical box.
2. Remove the two screws
○
1 that mount the fan motor F0
○
4 to the compressor base
○
2 .
3. Then take out the condenser fan motor and replace it. Make sure to refit the rubber washer
○
3 at the original designated position and replace it if aging.
4
3
2
1
