11
OPERATING YOUR WINE & BEVERAGE CENTER
INSTALLING THE STAINLESS STEEL HANDLE
This wine & beverage cooler includes a stainless steel handle that is not required to operate this unit.
To install the handle, please follow the below instructions:
①
Pull away the door gasket in the area where the handle is to
be installed. You can see two designated holes for handle
installation. The gasket is easily displaced by hand, no tools
are necessary.
②
Install the handle tightly as shown below with the two
screws, DO NOT over tighten as this will cause damage to
the handle assembly and stainless steel surface of the glass door .
③
Replace the door gasket to its original position.
Charcoal Filtration System
Your cellar is equipped with an active charcoal filtration system to ensure air purity and to maintain an odor free
cabinet for the storage of your wines.
The filter is located at the bottom of the rear panel inside your cellar. Keep in mind, that this filter must be changed
every 12 months. Place the carbon filter on top shelf.
1. Remove the bottles of wine stored on the two (2) shelves in front of the filter.
2. Remove the shelves and set aside to be replaced once you have changed the Filter.
3. Hold the filter and turn it at 45 degrees in the counter-clockwise direction and
then pull it out.
4. Remove the existing filter and replace with a new one.
5. Put the new filter into the hole and then turn the filter at 45 degrees in clockwise direction.
The settings can be changed using the control panel.
1. Functions of each keys in the control panel.
①
Up
Used to raise (warm) the set temperature by 1°C or 1°F. When the screen is flashing, press it once, the
temperature setting will go up by 1°C or 1°F. The highest setting temperature is 18°C (64°F). Stop pressing
any button for 5 seconds, then the number will stop flashing to show the actual temperature of the cabinet.
