background image

shading solutions by

VIMCO

TM

Lutron Electronics Co., Inc.
Made and printed in U.S.A.
P/N 045-008  Rev. C  3/03

LIMITED WARRANTY

SIVOIA

®

MOTORIZED WINDOW SHADE SYSTEM EIGHT YEAR LIMITED WARRANTY

Vimco warrants, for eight years from shipment, each new 

SIVOIA 

Motorized Window Shade System to be free from defects in materials or workmanship under

conditions of normal use and specified ambient temperature when installed and operated in accordance with Vimco product specifications, applicable local
electrical and building codes, applicable National Electrical Code

®

provisions, and the Safety Standards of Underwriter's Laboratories

.

What Vimco Will Do

Upon the return of a system or system component, subsequently determined by Vimco to be defective, Vimco will, in its sole discretion, repair or replace the
defective system or system component, provided that Vimco was promptly notified of the alleged defect within the warranty period, and provided that the
system or system component was properly installed, wired, insulated, used, and maintained, as determined solely by Vimco. Vimco shall not be required to
remove, install, or re-install any system or system component alleged to be defective.
Vimco will issue a credit for the cost of the repair or the replacement in accordance with the following schedule:
For the first 2 years after the date of shipment

100%

For years 3, 4, and 5 after the date of shipment

50%

For years 6, 7, and 8 after the date of shipment

25%

What This Warranty Does Not Cover

1. Damage or improper operation determined by Vimco to be due to normal wear and tear, or to abuse, misuse, or accident, such as:

a. Use of incorrect line voltages;
b. Use of incorrect fuses or circuit breakers;
c. Failure to follow operating instructions provided by Vimco;
d. Unauthorized repairs or adjustments or alterations;
e. Direct exposure to corrosive materials;
f. Vandalism;
g. Fire, flood, “Acts of God”, and other factors beyond the control of Vimco.

2. The cost of labor, including any labor required to remove, install, or re-program any replacement item.
3. Components and equipment external to the 

SIVOIA

Motorized Window Shade System, such as:

a. Non-Lutron lighting and automation systems;
b. Building wiring; and
c. Other manufacturers’ equipment, including, but not limited to:

i. Time clocks;
ii. Audio-visual equipment; and
iii. Photo sensors.

4. The cost of repairing or replacing property or equipment other than the warranted system

.

How to Get Service under This Warranty

Should you experience the need for service under this warranty, please contact your 

SIVOIA

Motorized Window Shade System service representative

immediately; or
Contact Vimco by telephone toll-free at:

1-800-446-1503

; or

By mail to:

VIMCO Shading Systems 
11520 Sun Shade Lane
Ashland, VA 23005

or;

By E-mail: 

[email protected]

LIMITATIONS AND EXCLUSIONS

THIS WARRANTY IS EXCLUSIVE. THERE ARE NO OTHER EXPRESS WARRANTIES.
THE IMPLIED WARRANTY OF MERCHANTABILITY IS LIMITED TO TWO YEARS FROM THE DATE OF SHIPMENT. VIMCO SHALL NOT BE LIABLE FOR
ANY REPAIR WORK UNDERTAKEN WITHOUT ITS PROPER WRITTEN CONSENT, OR FOR INCIDENTAL, CONSEQUENTIAL, OR SPECIAL DAMAGES.
VIMCO’S LIABILITY ON ANY CLAIM FOR DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE MANUFACTURE, SALE, INSTALLATION,
DELIVERY, USE, REPAIR, OR REPLACEMENT OF THE SHADING SYSTEM SHALL NEVER EXCEED THE PRICE PAID FOR THE SYSTEM. SOME
STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY TO YOU.

This product may be covered under one or more of the following U.S. Patents: 5,467,266; 5,671,387; 5,848,634; 6,100,659; 6,201,364; 6,313,588; 6,346,781 DES.
317,593; DES. 344,068; DES. 370,663; DES. 378,814; DES. 387,736 DES. 391,924; DES. 396,448; DES. 437,585; and DES 450,043; and corresponding foreign
patents. U.S. and foreign patents pending. Lutron, Sivoia, and the Sunburst logo are registered trademarks of Lutron Electronics Co., Inc. VIMCO and shading solutions
by VIMCO are trademarks of Virginia Iron & Metal Company, Inc. National Electrical Code is a registered trademark of the National Fire Protection Association, Quincy,
Massachusetts.
© 2003 Virginia Iron & Metal Company, Inc.

Internet: www.vimco.com, www.lutron.com

Summary of Contents for LUTRON Sivoia SV-MDU-HT-W-L

















Reviews: