SIVOIA QED
TM
Roller 64 Dual Mount
Installation Instructions
19
14
Finish System Programming
The Sivoia QED shade is now installed, wired, and the OPEN/CLOSE limits for each shade
have been set.
The next step is to finish programming the system.
Use the instructions in the
Wiring and Programming Guide
(p/n 045-038) or the
Technical
Reference Guide
(p/n 367-592) and perform these four easy steps:
1.
Address the system.
This gives each EDU, keypad and contact closure interface
in the system a unique address number or “name”, allowing proper communication
between components.
2.
Verify wiring
of each EDU, keypad and interface using the LED feedback from
each system component during addressing.
3.
Assign shades
(EDUs) to keypads, IR hand controls and/or contact closure
interfaces. Tell the system which shades (EDUs) respond to which keypads, IR
hand controls and contact closure interfaces.
4.
Set and save PRESET shade positions
if you desire them to be different from
the factory defaults.
Note:
Before addressing, all keypads will operate all shades. This can be used to verify proper
wiring and communication.
