Villager Villy 1800 P, Original Instruction Manual, Page: 22 / 142

Villager Villy 1800 P (GB)
7
-Do not tilt the lawn mower when switching on the motor, except if the
lawnmower has to be tilted for starting. In this case, do not tilt it more than
absolutely necessary and lift only the part which is away from the operator.
-Do not pull your machine towards you or walk backwards - when mowing.
-Walk, never runs.
Always mow across the face or slopes, never up and down.
Exercise extreme caution when changing direction on slopes. Do not mow
excessively steep slopes and always wear non-slip foot wear.
-Mow only in daylight or in good artificial light.
-Never use the mower without the grass-bag in place.
-Check grass bag frequently for wear or damage.
-Switch the motor off and wait until the blade comes to a complete stop before
removing the grass catcher or unclogging chute.
-Disengage the self-propelled mechanism or drive clutch on units so equipped
before switching on the motor.
-Never attempt to make a wheel height adjustment while the motor is running.
-Do not switch on the motor - when standing in front of the discharge chute.
-Do not put hands or feet near or under rotating parts. Keep clear off the
discharge opening at all times.
-If the equipment should start to vibrate abnormally, switch off the motor and
check immediately for the cause. Vibration is generally a warning of trouble.
-The cutting edges of the mower blade are sharp and can lacerate (cut) skin
tissue. Care should be taken when doing any repair work on or around the
mower blade. To prevent injury, it is recommended that gloves be worn or the
cutting edge be wrapped with newspaper or any other suitable material when
working on the blade.
-Do not use solvent or cleaning fluids to clean your machine-use a blunt scraper
to remove grass and dirt. Always disconnect from the electrical supply before
cleaning.
-Store your machine in a dry place when not in use, preferably out of the reach
of children.
ELECTRICAL SAFETY
-Your machine is designed for use on a.c. electrical supplies only. Do not
attempt to use on any other supply. Plug your machine into a power point, not
a light socket.
-Your machine is double insulated
. This means that all external metal parts
are electrically isolated from the power supply. This is achieved by placing an
extra insulation barrier between the electrical and mechanical parts. Double
insulation means greater electrical safety and obviates the necessity of having
the machine earthed.