E4
DrawerMicro Oven
Measurements
• Dimensions that are shown in figure
1
must
be used. Given dimensions provide minimum
clearance. Locate electrical outlet in the shaded
area in the upper left-hand corner of the cutout.
See figure
4
.
• Contact surface must be solid and level. Pay
special attention to the floor on which the
appliance will sit. The floor of the opening should
be constructed of plywood strong enough to
support the weight of the oven (about 100
pounds).
• Check location where the DrawerMicro Oven will
be installed for proper electrical supply.
• Your appliance can be built into a cabinet or wall
by itself or under a gas or electric wall oven.
• Be sure that the clearance of the floor between
the wall oven and the DrawerMicro Oven is a
minimum of 2".
• The microwave interior will easily accommodate
a 9" x 13" oblong dish or a bag of microwave
popcorn.
Anti-Tip Block
NORMAL INSTALLATION STEPS
Anti-Tip Block Installation Instructions
• To reduce the risk of tipping of the drawer, the
Anti-Tip block must be properly installed located
14-13/16" above the floor on which the appliance
will sit. The 6" Anti-Tip block must be provided
by the installer. See figure
1
. The Anti-Tip block
prevents serious injury that might result from
spilled hot liquids.
36"
counter-
top
height
24"
cabinet min.
22
¹⁄₈
"
opening
14
¹³₁₆
"
opening
Allow
⁷₁₆
"
overlap
Allow ¾"
overlap.
Allow ¾"
overlap.
Approximately
19"or less
(recommended)
4"
5"
Electrical outlet location
Anti-Tip
block
Floor must
support
100 lbs.
14
¹³₁₆
"
to bottom
of Anti-Tip
block
3
¹⁄₂
"
(6")
23 ½"
min depth
Allow
³₈
"
overlap
21
¹⁹⁄₃₂
"
23
³⁄₈
"
14
¹⁹⁄₃₂
"
1
³⁄₄
"
door thickness
15
⁵⁄₈
"
23
⁷⁄₈
"
15"
auto drawer
opening
1
²³⁄₃₂
"
4
¹¹⁄₁₆
"
DRAWERMICRO OVEN MEASUREMENTS:
Figures
1
and
2
contain many DrawerMicro Oven measurements for reference
when planning the drawer’s location which can be installed
below any electric or gas wall oven. It can also be installed
using an electrical outlet in an adjacent cabinet within the
area where the provided electrical cord can reach. Power cord
access hole in cabinet should be a minimum 1½" diameter hole
and deburred of all sharp edges.
IMPORTANT:
Always allow sufficient power cord length to the
electrical outlet to prevent tension.
DO NOT USE AN EXTENSION CORD. If the power supply cord
is too short, have a qualified electrician or serviceman install
an outlet near the appliance.
Always check electrical codes for requirements.
Clearances and Dimensions
2
1
