Viking PRX-4 Product Manual Download Page 3

Operation

Programming

The red LED on the front of the 

PRX-4

will light steady to show the keypad is powered up,

and blink yellow with each key stroke. A beep tone will also acknowledge each time a key
is pressed. To gain access, enter the keyless entry code, followed by the “

#

” key.

Important:

26-bit Wiegand data limits the entry code range from 00001 to 65534.

Warning:

Do not program the Viking 

ES-1

C-4000

AES-2000

or any other entry system

to accept code number 65535. The 

PRX-4

keypad outputs 65535 as an error code.  An

error code is given if one of these three sequences happen:

1. 

Pressing the “#” key with no preceding digits.

2. 

Pressing any number of only zeros prior to pressing the “#” key.

3. 

Pressing 65535 or any number above 65535.

The 

PRX-4

is factory programmed with the facility code cleared (000). To program a facility

code, press “

Q

” during the first 3 seconds from when the unit powers up. Then (within 10

seconds) enter any number 000 to 255 as its facility code, followed by “

#

”.

Summary of Contents for PRX-4

Page 1: ... gasket sealed connections as well as an epoxy potted cir cuit board For more information see DOD 859 Standard 26 bit Wiegand interface Designed for outdoor use the PRX 4 comes standard with Enhanced Weather Protection EWP PRX 4 is designed to meet IP66 Ingress Protection Rating see DOD 859 Pigtail connection for easy installation Bi color LED shows activity Screw protection caps Beep tones acknow...

Page 2: ...y four touch tone phones into multi number auto dialers that will store up to 250 telephone numbers in non volatile memory When a call initiated by the C 4000 is answered by an apartment or busi ness tenant a built in contact closure may be activated to control an elec tric gate or door strike See DOD 164 for more info Stand Alone Door Controller Entry System The ES 1 is a door controller designed...

Page 3: ...iking ES 1 C 4000 AES 2000 or any other entry system to accept code number 65535 The PRX 4 keypad outputs 65535 as an error code An error code is given if one of these three sequences happen 1 Pressing the key with no preceding digits 2 Pressing any number of only zeros prior to pressing the key 3 Pressing 65535 or any number above 65535 The PRX 4 is factory programmed with the facility code clear...

Page 4: ...eshooting a Return Authorization R A number will be issued This number is valid for fourteen 14 calendar days from the date of issue 3 After obtaining the R A number return the approved equipment to your distributor referencing the R A number Your distributor will then replace the product over Viking using the same R A number 4 The distributor will NOT exchange this product without first obtaining...

Reviews: