1.3 Download and install the programming software
1. Go to
www.vikingelectronics.com
and enter
PA-250-IP
in the search box
2. Click
PA-250-IP
in the search results
3. Scroll down the page to Downloads, click
IP Programming Software
4. Install the programming software by saving or opening the file and then clicking on
setup Viking IP Programming.exe
5. Follow the prompts on your screen to complete software installation
QUICK START GUIDE
VIKING
Electronics, Inc.
K
See Product Manual for complete installation and programming instructions.
1.0 Out-of-Box
1.1 Verify that you have received all of the parts listed
1.2 Download the product manual
1. Go to
www.vikingelectronics.com
and
enter
PA-250-IP
in the search box
2. Under Documents click
Product Manual
to open and download the PDF
Scan the QR code to
open and download
the product manual
- OR -
PA-250-IP
250 Watt 70V SIP /
Multicast Paging Amplifier
January 22, 2021
X 1
Terminal Strip 4 Pin 5mm
Right Angle Removable
X 1
Terminal Strip 5 Pin 5mm
Right Angle Removable
X 1
Terminal Strip 2 Pin 5mm
Right Angle Removable
X 1
PA-250-IP
X 1
Y Power Cord
X 1
Bit slotted 2.5 mm
• Make sure the port is not in trunk mode
• Make sure port is capable of 100mbps full duplex
• Disable Spanning Tree Protocol (STP) or enable Portfast
2.0 Network Port Settings
