Viking MR 4082, Instruction Manual

Page: 94 / 420

0478 193 9902 A - EN
92
Fit V-belt (2) onto V-belt pulley (6).
When fitting, ensure that the V-belt is
installed correctly (not twisted).
● Slowly release V-belt tensioner lever (5)
and ensure that the V-belt is routed
correctly in the V-belt pulley.
● Install the discharge chute. ( Ö 14.6)
● Install the grass catcher box. ( Ö 12.10)
Installing the rear V-belt cover
● Select the lowest cutting level.
Insert the rear V-belt cover (1) with the
retaining device at the locating lug (2) on
the gearbox (3) in direction of arrow.
Push rear V-belt cover (1) upwards and
hold. Turn the closure screw (2) clockwise
through 90°.
General maintenance instructions:
● The maintenance schedule and
maintenance intervals must be strictly
observed.
● Observe the maintenance schedule
and maintenance operations in the
engine instruction manual.
Risk of injury:
After attaching the mowing deck,
perform an operational check.
Ensure that no other persons,
particularly children or animals are
in the vicinity. Only perform the
operational check when the user is
sitting on the machine.
Danger of burns:
Allow the machine, particularly the
exhaust system to cool down
completely before installing the rear
V-belt cover.
Note
After installing, check that the rear
V-belt cover is seated securely.
Avoid damage to the machine.
After installation, the V-belt must be
free and must not contact the rear
V-belt cover.
Check this visually.
14. Maintenance
Risk of injury!
Before all maintenance and repair
operations, carefully read and
observe the section "For your
safety" and especially the
subsection "Maintenance and
repairs". (
Ö 4.)
Remove the ignition key
to prevent inadvertent
starting of the engine.
Always wear gloves.
Never touch the mowing
blades before they have
come to a standstill.
For safety reasons, maintenance
operations on the brakes are not
permitted. Only allow adjustment
and maintenance operations to be
performed by a specialist dealer.
VIKING recommends
VIKING specialist dealers.