9
This timer sets the maximum amount of time the
K-1205
will look for the call to be answered. If this timer expires
and the tenant has not answered, the call will be terminated or the
K-1205
will dial a second phone number (if
programmed). The factory setting is 20 seconds, and to disable this feature, enter “
00
” into position 43.
J. Maximum Ring Time
This time out is started once the call has been connected and is reset every time audio is detected on the phone
line. If it expires, the call will be terminated. This is useful on systems that are silent when the tenant hangs up to
assure the
K-1205
disconnects. It is factory set to 10 seconds and can be disabled by entering “
00
” in position
44.
K. Silence Time Out
This time represents the amount of time the
K-1205
will delay before switching back to the microphone mode
after it was in the speaker mode (VOX switching time). It is in 100 msec increments and stored in position 45.
L. Talk/Listen Delay
On some phone lines, a faster rate of dialing is allowed. The dialing speed of the
K-1205
can be altered to take
advantage of this faster rate. The normal dialing speed is 5 digits per second and is selected by entering “
#30
”
(factory setting) while in programming. To increase the speed to 10 digits per second, enter “
#31
”. If the faster
rate is selected, be sure to test each number to assure proper operation.
M. Dialing Speed
A one or two digit door strike code can be entered by
programming position
#41
. When in programming, enter
the one or two digit code followed by “
#41
”.
Note:
“
Q
”
and “
#
” can be entered as valid characters of the door
strike code by substituting “#20” and #21” (respectively)
when programming the door strike code (see section
D
).
To disable the door strike relay, enter “
#41
” without
any preceding numbers. Examples of door strike code
entries are shown to the right.
H. Door Strike Code
The actual time the door strike relay is energized is controlled by location
#40
. The time can be set from 00 to 99
seconds, (an entry of “00” gives 0.5 seconds). In order to use this feature, be sure the relay door strike code is
set (see section
H
).
G. Door Strike Time
In some installations, it maybe desirable to limit the length of the call to the tenant. This can be done by
programming position
#42
. The maximum call time can be set from 1 minute to 9 minutes by entering the
appropriate number in position
#42
. A “
0
” will yield a 30 second time. To disable the call timer enter “
#42
” without
any preceding digit.
I. Maximum Call Time
To Program the
Door Strike Code to...
Step 1
(see section A)
Step 2
Enter Digits
“99”
Enter programming
99#41
“3”
Enter programming
3#41
“
”
Enter programming
#20#20#41
“#1”
Enter programming
#211#41
“
Q
”
Enter programming
#20#41
