Viking HB 445 R, Instruction Manual

Page: 30 / 472

0478 403 9801 C - EN
28
7. 1 Installation instructions
● Perform all the operations described on
a clean, flat, level and firm surface.
● Observe installation position – always
ensure that the machine is standing
stably and securely.
● Strictly observe instructions for cable
installation. In particular, fasten all
cables to the handlebar using
cable
ties in order to prevent damage to the
machine (e.g. when folding down the
handlebar) or possible malfunctions.
Self-propulsion levers, drive cables
HB 445:
– Black self-propulsion lever on the upper
side of the handlebar.
– One drive cable (forwards).
HB 445 R, HB 560, HB 585, HB 685:
– Black self-propulsion lever on the upper
side of the handlebar.
– Red self-propulsion lever on the
underside of the handlebar.
– One drive cable (forwards). The cable is
fitted with a black cap and must be
attached to the black self-propulsion
lever.
– One drive cable (reverse). The cable is
fitted with a red cap and must be
attached to the red self-propulsion
lever.
7.2 Attaching the chassis
● Installation position:
Tilt basic unit (A) forwards as
shown and support at both drive shafts
using suitable wooden blocks (1)
(height 50 - 60 mm, width/length
approx. 100 mm).
● 1 Press retaining clasp (2) upwards
and hold.
● 2 Insert transport chassis (D) into
recess (3) in the pin of release lever (4).
● Press transport chassis (D) upwards to
the stop and hold.
● 3 Press retaining clasp (2)
downwards. Insert bolts (T) on both
sides from below.
● 4 Secure retaining clasp (2) by
tightening both nuts (U).
7.3 Installing the brake spur
● Installation position:
see "Attaching the chassis"
(
Ö 7.2)
● Press release pin (1) and hold.
H HB 445, HB 445 R:
Hoe
4
I HB 560, HB 585, HB 685:
Dual hoe
2
J HB 585, HB 685:
Single hoe
2
K Protection ring 2
L Plant protection disc 2
M Self-propulsion lever
(forwards) black
1
N HB 445 R, HB 560,
HB 585, HB 685:
Self-propulsion lever
(reverse) red
1
O HB 445:
Lock nut M6
1
P HB 445:
Cover 1
Q Lock nut M6 1
R Flat head bolt M6 1
S HB 445, HB 445 R,
HB 585, HB 685:
Folding retainer 10x40
HB 560:
Folding retainer 10x40
6
4
T Flat head bolt M8 2
U Hexagon nut M8 2
V Cable tie 2
– Instruction manual 1
– Instruction manual
Engine
1
– HB 560, HB 585, HB 685:
Spark plug wrench
1
Item Designation Qty.
7. Preparing the machine for
operation
Risk of injury!
Observe the safety instructions in
the "For your safety" section. (
Ö 4.)
In particular, detach the spark plug
socket and always wear thick
gloves when carrying out any work
on the hoes.
Observe the specified torque.
Only route and attach drive cables
and throttle cable as described.
Incorrectly installed cables (e.g.
incorrect routing or attaching to the
wrong self-propulsion lever) may
cause malfunctions.
3
4