Viking GB 460, Instruction Manual

Page: 61 / 656

59
DE
FR
NL
IT
ES
PT
NO
SV
FI
DA
PL
SK
HU
HR
EN
0478 216 9905 A - EN
7.3 Removing the blade cover
●
Hold the blade cover (1) at the
bore and lift off the cover.
7.4 Installing the blade cover
●
Insert the blade cover (1) under
the counter-blade (2).
Then press down the blade cover (1).
When properly installed, the blade
cover (1) must lie against the blade disc
correctly.
7.5 Installing the feed chute
ATO 400
●
Remove the blade cover. (
Ö
7.3)
●
Insert the two fastening hooks (1) on
feed chute ATO 400 (K) into the two
openings in the basic unit (2).
●
Tilt the feed chute ATO 400 (K)
forwards to the stop.
●
Screw in the On / Off switch (3) and
tighten.
7.6 Installing the ejection chute
extension
●
Carefully set the machine on its
back.
Installing the ejection chute extension
●
Attach the ejection chute extension (L),
engage the hooks (1) in the apertures
on the housing (2) from above, turn
downwards and push on the
retainers (3) at the side.
●
Screw in the screws (O) and tighten to
1
-
2 Nm
.
●
Loosen the screw (4) at the left wheel
carrier by approx. 5 turns.
7.7 Installing the plates
1
Install the guiding plate
●
Insert the guiding plate (N).
Ensure that the guides on the guiding
plate (1) are correctly located in the
guides of the ejection chute
extension (2).
●
Fit screw (P) and tighten with nut (R).
●
Screw in the screws (O) and tighten to
1
-
2 Nm
.
2
Install the ejection chute plate
●
Insert the ejection chute plate (M).
●
Screw in the screws (O) and tighten to
1
-
2 Nm
.
●
Fit screws (Q) and tighten with nuts (R).
Any slight tensions occurring in the
ejection chute can be compensated by
readjusting the screws.
Tightening the screws of the
wheel carrier mounting
●
Stand the machine up and check
for correct seating of all attached parts.
●
Tighten screws (1, 2) of the wheel
carrier mounting to
1
0
-
1
2 Nm
.
7.8 Fuel and engine oil
Engine oil
Please consult the engine instruction
manual for the type of engine oil to be used
and the oil capacity. Check the oil filling
level at regular intervals (
Ö
see engine
instruction manual). Avoid exceeding or
falling below the correct oil level.
Fuel
Recommendation:
Fresh good quality fuel, normal unleaded
petrol (
Ö
engine instruction manual)! Use
a funnel when filling the tank with fuel (not
included in standard equipment). Note the
warnings in the section "For your safety".
(
Ö
4.)
Following assembly, check that the
feed chute ATO 400 is correctly
engaged in both openings in the
basic unit.
Place cardboard underneath in
order to prevent damage.
5
6
7
8
In order to facilitate installation of
the guiding plate, we recommend
loosening the left wheel carrier
slightly.
9
After tightening screws, check that
both wheel carriers are securely
seated.
Top up engine oil before initial start
(
Ö
engine instruction manual)!
1
0
11