2
Features Overview
Installation
Internal View of the FXI-1A
Red power LED
will be OFF
For POT Settings,
See Programming
Section B
Note: DIP Switch 4 and 5 must
be OFF.
See Programming section A.
600 Ohm Audio Out to Paging Amplifier
See Installation Sections B and C
4
3
2
1
5
4
3
2
1
FXS Port or Ringing PABX Extension
ON
1 2 3 4 5
ON OFF
Talk Battery
Switch
FXS
Talk Battery
Switch
Internal View of the FXI-1A
Active LED: Lights Blue when Paging
Power LED: Red
Power Input: 12VDC (included)
not needed in Ring Trip Mode
(2) #6 x 3/4” Panhead Screws (Included)
600 Ohm Audio Out
Background Music Input
Night Bell
10
9
8
7
6
5
4
3
2
1
Normally closed Relay Contact
Common Relay Contact
Normally Open Relay Contact
Audio In: FXS (Ring trip), FXO (Loop Start),
or VOX (Page Port) Input
ON
1 2 3 4 5
Enable Page Port Operation
Enable VOX Mode
VOX Sensitivity
Enable Busy Detect
Enable Pre-Page Alert Tone
FXS
FXO
ON OFF
Silence Time Out: Adjustable
from 2.5 to 10 seconds or
disable
Page Time Out: Adjustable
from 5 to 60 seconds or
disable
Master Volume Control
A. Page Input Type
1. FXS (Ring Trip) Mode (Not Using the Included Power Supply)
Use one of the following three diagrams (depending on the type of page input that will be used), to
connect the paging source. In all three cases, the 600 Ohm Audio Output can connect to a paging
amplifier. The Relay Contacts can be used to either switch in and out background music (See
Installation section B), or trigger the paging amp (See Installation section C).
Select this mode if connecting to a FXS Port, or a Ringing PABX Extension. The
FXI-1A
will
answer a ringing line, activate its relay, and pass the paging audio onto the amplifier. It will then
drop the call based on Page Time Out, Silence Time Out, detecting a Busy Signal or Calling
Party Control (CPC). See Operation section A for further details.
IMPORTANT:
Electronic devices are susceptible to lightning and power station electrical surges from both the AC
outlet and the telephone line. It is recommended that a surge protector be installed to protect against such surges.
Switch
Talk
Battery
For use with
FXS
OFF
Ring Trip and
Page Port
FXO
ON
Loop Start