8
ELECTRICAL REQUIREMENTS
Check your local codes regarding this unit. This oven requires a 4-wire with ground, 240-208/120 VAC/60 Hz,
30 amp electrical connection for the single oven and 60 amp electrical connection for the double oven. This unit is
equipped with a No.10 ground wire in the conduit. See next section for grounding instructions. It should be fused
separately.
CAUTION
:: Be sure the electric power is off from the breaker box to the junction box until the oven is
installed and ready to operate. The junction box should be located as shown in the drawing and connected to
suitable ground.
Refer to the specification chart for watt rating and recommended amps. House wiring and fusing must comply with
local codes. If no local codes are applicable, wire in accordance with the National Electrical Code, ANSI/NFPA 70-
latest edition.
ELECTRICAL CONNECTION
With the oven positioned in front of the cabinet opening, connect the wire leads extending from the conduit to
the junction box, making sure the neutral (white) wire is connected to the appropriate terminal. Check your local
code to see which of the options below should be used in grounding the unit.
OPTION 1:
Connect the neutral (white) wire and the grounding (green) wire with the incoming neutral
(white) power supply line.
OPTION 2:
If the junction box is grounded, untwist the grounding (green) wire and attach to the junction
box. Attach the neutral (white) wire to the neutral (white) power supply line.
OPTION 3:
Untwist the grounding (green) wire and attach it to a suitable ground. Attach neutral (white)
wire to the incoming neutral (white) power supply line.
DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE. SUCH USE MAY RESULT IN A FIRE, ELECTRICAL SHOCK OR
OTHER PERSONAL INJURY.
CHECK WIRING
Connect the electric power at the breaker box and check for proper operation of all functions.
DOOR REMOVAL / door and
trim ADJUSTMENT
WARNING:
Do not use handle/oven door to
lift unit. Remove door before installing to
ensure handle/oven door is not used to lift unit.
Ocassionally, it may be necessary to remove
or adjust the doors. This should only be done by
a qualified techinican. To remove the door, open
the door to the full open position. Place a pin in
the pinhole on the hinge. Close the door just until
it reaches the pin in the hinge. Remove the
screws from the top of the hinge trim and remove
the hinge trim. Lift up and out on the door until
the door comes out of the door socket. Reverse
the procedure to replace the door.
To adjust the door up or down, turn the
adjustment screw. To move the door up, turn the
adjustment screw clockwise. To move the door
down, turn the adjustment screw counterclockwise.
Hinge Trim
Trim Screw
Pinhole
Adjustment
screw
If trim adjustment is required to flush the trim with the cabinet, loosen the screws that attach the trim to the oven and
adjust the trim in the slotted holes. Retighten the screws.
