21
Performance Checklist
A qualified installer should carry out the
following checks:
1.
Check oven bake function–bake element on
full power, center and outside broil elements
at partial power. Convection bake function–
bake and broil elements the same with the
convection fan on.
2.
Check TruConvec™ function– TruConvec
element (behind convection fan cover) on
and convection fan on.
3.
Check high broil function–both broil
elements at full power. Convection broil
function is the same with convection fan on.
4.
Check medium broil function–inner and
outer broil elements pulse on and off.
5.
Check low broil function–inner broil element
only.
6.
Check self-clean function–Door will lock in
approximately 30 seconds, the center and
outside broil elements will turn on and the
bake element will turn on at partial power.
Check broil elements through window to
make sure they are on, then abort self-clean
cycle to unlock door.
CAUTION:
Do not run self-clean cycle check
for more than 10 minutes with the oven racks
and rack supports inside oven to avoid
discoloration due to the high temperature.
Any adjustments necessary that are a result of
the installer not following instructions will be
the responsibility of the installer, dealer or the
end user of the product.
20
Replace door.
Take out pins.
Note:
To adjust door turn adjustment screw
clockwise (up) or counterclockwise (down).
Close door.
Open door completely. Put hinge trim plates back on.
Note:
Screw holes may need to be re-aligned.
13
14
15
16
Installation Procedure
(continued)
