15
14
DO
WN
UP
7a
DO
WN
UP
DO
WN
UP
DOWN
UP
Equal distance
7b
OW
N
UP
OW
N
UP
OW
N
UP
OW
N
UP
OW
N
UP
OW
N
UP
OW
N
UP
OW
N
UP
1
2
Equal distance
8
For 301 models, place a level on handle, then adjust to
appropriate height. Left and right adjust side to side
and center adjusts front to back.
For 201 models, remove front panel to access the front
leveling legs. Leveling legs will be raised during
shipping. Adjust front leveling legs down using a 1/4
drive ratchet. When the adjustment nut is visible,
complete the lowering of the legs from the top. When
the legs are down, tighten the locking nut on the top
of the leg. To level center rear leg, see Step 7a.
To check level, front to back, pull the top rack half-way out of
unit. The rack should remain stationary and not move in or out.
Note:
Leveling is important for optimal performance.
Leveling
9
x2
Attach screws through bracket into cabinets.
Minimum
20”
(50.8 cm)
from floor
10
Install High Loop Clip, which is provided, a minimum of
20” (50.8 cm) from the floor. Refer to the Drain section
of
"General Information"
for proper installation
requirements.
1.0”
(2.5 cm)
Cut here for
3/4” (1.9 cm)
Cut here for
5/8” (1.6 cm)
11
Identify discharge connection size; cut line to correct
size and connect. Clamp if necessary.
12a
12b
(Discharge with food waste disposer)
Note:
Be sure to remove the knockout or plug from the
fitting of the disposer before connecting drain line.
(Standard discharge)
Final Installation
12c
Air Gap
(Discharge with air gap)
12d
Air Gap
(Discharge with food waste disposer and air gap)
13
Connect water line.
