11
Any piece of equipment works better and lasts longer when maintained properly and kept clean. Cooking equipment is no
exception. Your rangetop must be kept clean and maintained properly. Before cleaning, make sure all controls are in the
“OFF” position. Disconnect power if you are going to clean thoroughly with water.
Surface Burners
*Note:
When replacing burner head, arrow must be pointing towards back of rangetop.
Wipe up spillovers as soon as possible after they occur and before they get a chance to burn in and cook solid. In the event
of a spill-over, follow these steps:
• Allow the burner and grate to cool to a safe temperature level.
• Lift off the burner grate. Wash in warm soapy water.
• Remove the burner cap and burner head and clean.
Burner Caps
The surface burner caps should be routinely removed and
cleaned. ALWAYS clean the burner caps after a spill-over.
Keeping the burner caps clean will prevent improper ignition
and uneven flames. To clean, pull burner cap straight up from
the burner base. Wipe off surface burner caps with warm, soapy
water and a soft cloth after each use. Use a non-abrasive
cleanser such as Bon Ami™ and a soft brush or soft Scotch
Brite™ pad for cooked-on foods. Dry thoroughly after cleaning.
For best cleaning and to avoid possible rusting, DO NOT clean
in dishwasher or self-cleaning oven.
Burner Head
If ports on burner head are clogged, clean with a straight pin. DO NOT enlarge or distort the ports. DO NOT use a
toothpick to clean the ports. When replacing burner head, carefully align the 2 tabs underneath the burner head with the
outside edge of burner base. Make sure the tabs are not aligned with the igniter and the burner cap is level.
Note:
For stubborn stains, use a non abrasive cleanser such as Bon Ami™ and a soft brush or soft Scotch Brite™ pad.
Cleaning Tip:
For difficult to clean burner caps and heads, place parts in a zip seal bag with ammonia.
Burner Base
The base should be wiped regularly with hot soapy water at the end of each cooling period. DO NOT use steel wool,
abrasive cloths, cleanser, or powders. To remove encrusted materials, soak the area with a hot towel to loosen the material,
then use a wooden nylon spatula.
DO NOT use a metal knife, spatula, or any other metal tool to scrape the aluminum base.
• Wipe up any spills which remain on the sealed top surface.
• Replace burner cap, burner head, and grates after drying thoroughly.
Burner
grate
Burner
cap
Burner
head
Burner
base*
Igniter
Cleaning and Maintenance
Product Care
Summary of Contents for CVGRT530
Page 15: ...15...
