40-IP
SIP Multicast Speaker
January 17, 2019
1.0 Out-of-Box
1.1 Verify that you have received all of the parts listed
40-IP Speaker
Qty:
1
4-position terminal block
Qty:
1
• Make sure the port is not in trunk mode
• Make sure port is capable of 100mbps full duplex
• Disable Spanning Tree Protocol (STP) or enable Portfast
QUICK START GUIDE
VIKING
Electronics, Inc.
3.0 Network Port Settings
1.3 Download and install the programming software
1. Go to www.vikingelectronics.com and enter
40-IP
in the search box
2. Click
40-IP
in the search results
3. Scroll down the page to Downloads, click
IP Programming Software
4. Install the programming software by saving or opening the file and then clicking on
setup Viking IP Programming.exe
5. Follow the prompts on your screen to complete software installation
K
See Product Manual for complete installation and programming instructions.
2.0 Power Source
Select
PoE Switch
or
PoE Injector
that meets the following requirements:
1. IEEE 802.3af / 802.3at / 802.3bu compliant
2. Capable of providing at least 13 Watts (class 0 or class 3)
Note:
CAT5e (or higher) cable recommended
1.2 Download the product manual
1. Go to
www.vikingelectronics.com
and
enter
40-IP
in the search box
2. Click
40-IP
in the search results
3. Click
Product Manual
to open and
download the PDF
- OR -
Scan the QR code to
open and download
the product manual
