Viking VK1810 &
VK1810W
18x10w RGBW Led Par
Instructions
This Led light is designed to create washes, together with DMX or stand alone
control, using the built in programs or DMX Controller. The unit retains the preset
colour or function when switched off.
It uses 10 x 4 in 1 Led for RGBW colour mixing with Powercon in and out for
mains operation. DMX input and output is via 3 pin XLR connectors. The high output
40 degree lenses give excellent coverage.
The unit is fitted with an external 20mm 3a fuse for easy replacement and to protect the
unit & electronics from mains surges.
The unit can be floor standing or hung via it’s double yoke which has a secure lock-off
screw knob to lock in position.
To set DMX address and other menu options the light is equipped with a large clear
LED display panel with 4 buttons which are used to select operation mode etc.
Channel
Value
Function
1
0-255
Master Dimmer
2
0-255
Strobe
Operating (Control) Mode
0-50
DMX Control 8 Channel Mode
51-100
Colour Snap Change Auto Mode
3
101-150
Slowly Fade between Colours Auto Mode
151-200
Gradual Change: B/O between colours Auto Mode
201-255
Sound to Light
4
0-255
Control Mode Speed
5
0-255
Red LED from Dark to Bright
6
0-255
Green LED from Dark to Bright
7
0-255
Blue LED from Dark to Bright
8
0-255
White LED from Dark to Bright
Display
Value
Function
D001
1-512
DMX Address of unit
CC00
01-99
Colour Change: Snap from Slow to Fast
CP00
01-99
Colour Change Gradual: b/o between colours: Slow to Fast
DE00
01-99
Colour Change: Fade: from Slow to Fast
BEBE
Sound to Light
R000
0-255
Manual Red Led Brightness
G000
0-255
Manual Green Led Brightness
B000
0-255
Manual Blue Led Brightness
o000
0-50
Manual White Led Brightness
DMX Channels (8 Channels)
Display Settings:
M80
Care of your LED Fixture
Please note that these lights MUST NOT be powered through a
Dimmer or Non-dim (Dimmer set to switch mode)
Power for LED Lights must be from a constant 13a supply
(13a socket) only. If in doubt please ask before connecting.
Please note:
This Led light is designed to create washes, it is not recommended
to use all 4 colours (RGB &W) at full output simultaneously to create an extra
bright white light for anything other than short periods of time. Use over an
extended time in excess of 15 minutes will overhead the LED chips and cause
their failure which is not covered by the guarantee.
LED Lights use a technique called constant voltage so even when no light
output is visible they are in fact still working. Therefore ensure the lights are
switched off or unplugged when not in use.
Continued overleaf…….
