PUMP 1
Press the “Pump 1” button once to activate the low speed of the pri-
mary pump and again for the high speed. Press the “Pump 1” button
again to turn off the pump. If left running, the pump’s high speed will
automatically turn off
after 20 minutes
. The low speed of the pump
runs when the secondary pump is on. It may also activate for at least
2 minutes every 30 minutes to detect the spa temperature and then to
heat to the set temperature, if needed, depending upon mode. When
the low speed turns on automatically, it cannot be deactivated from the
panel, however, the high speed may be started.
PUMP 2
This button is used to turn the secondary pump on and off. If left on,
the pump automatically turns off
after 20 minutes
.
LIGHT
Press the “Light” button to turn the light on and off. If left on, the light
automatically turns off
after 4 hours
. In spas equipped with LED
light, press the light button consecutively to change the color sequenc-
ing.
MODE
The mode is changed by pressing the “Temp” button, then pressing the
“Light” button.
Standard Mode
is programmed to maintain the desired
temperature. Note that the last measured spa temperature displayed
is current only when the pump has been running for at least 2
minutes. “
St
” will be displayed momentarily when you switch into
Standard mode.
Economy Mode
heats the spa to the set temperature only during
filter cycles. “
Ec
” will display solid when temperature is not current,
and will alternate with temperature when temperature is current.
Sleep Mode
heats the spa to within 20°F/10°C of the set
temperature only during filter cycles. “
SL
” will display solid when
temperature is not current, and will alternate with temperature when
temperature is current.
16
