14
• Never attempt to repair or perform maintenance on
the appliance until the main electrical power has been
disconnected. Turning the appliance control "OFF"
does not remove electrical power from the units wiring.
• Replace all parts and panels before operating.
!
WARNING
Electrocution Hazard
Before You Call for Service
If the appliance appears to be malfunctioning, read through
this manual
fi
rst. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a quali
fi
ed service technician.
TROUBLESHOOTING
Problem
Possible Cause
Remedy
Appliance not cold enough
(See “Adjusting the temperature" on page
10)
•
Control set too warm
•
Content temperature not stabilized.
•
Excessive usage or prolonged drawer
openings.
• Air
fl
ow to front grille blocked.
•
Drawer gasket not sealing properly.
•
Adjust temperature colder. Allow 24
hours for temperature to stabilize.
•
Allow temperature to stabilize for at
least 24 hours.
• Air
fl
ow must not be obstructed to front
grille. See “clearances” on
page 4.
•
Adjust or replace drawer gasket.
Appliance too cold
(See “Adjusting the Temperature” on page
10)
•
Control set too cold
•
Drawer gasket not sealing properly.
•
Adjust temperature warmer.
Allow 24 hours for temperature to
stabilize.
•
Adjust or replace drawer gasket.
No interior light.
•
Failed LED light assembly or light
switch.
•
Contact a quali
fi
ed service technician.
Light will not go out when drawer is closed
•
Drawer not activating light switch.
•
Failed light switch
•
Appliance not level, level appliance,
(See page 4, “leveling legs”)
•
Contact a quali
fi
ed service technician.
Noise or Vibration
•
Appliance not level
•
Fan hitting tube obstruction.
•
Level appliance, see “Leveling Legs”
on page 4.
•
Contact a quali
fi
ed service technician.
Appliance will not run.
•
Appliance turned off
•
Power cord not plugged in.
•
No power at outlet.
•
Turn appliance on. See “Starting your
appliance” on page 10.
•
Plug in power cord.
•
Check house circuit.
!
CAUTION
In the unlikely event you lose cooling in your unit,
do not
unplug the product from the electric supply
, but do call
a quali
fi
ed service technician immediately. It is possible
that the loss of cooling capacity is a result of excessive
frost build-up on the evaporator cooling coil. In this case,
removing power to the unit will result in the melting of this
excessive quantity of ice, which could generate melt water
that exceeds the capacity of the defrost drain system and
could result in water damage to your home. The end-user
will be ultimately responsible for any water damage caused
by prematurely turning the unit off without appropriately
managing the excess water run-off.
