3. Getting started – regards complete IR detection kit
3.1. Unpacking
Before unpacking, verify if there are no visible damages of the package. Report them to the manufacturer or
the distributor.
3.2. Installation & connections
•
Mount the IR module in the measurement setup,
•
Connect all elements with cables provided in the package,
•
Make sure that all the elements are properly connected.
3.3. Switching on procedure
•
Do not switch on the IR module power supply until ALL elements of the IR detection kit are properly connec-
ted with the proper cables.
•
Switch on the thermoelectric cooler controller and wait until detector operating temperature is reached and
stabilized. Ready state will be indicated by the „LOCK” green LED light.
•
Before starting the measurements make sure the load resistance is valid. IR detector module output should
be terminated by 50Ω or 1MΩ resistance depending on the bandwidth and is given in the test data provided
on the module.
•
Do not manipulate any connectors on the active IR kit – this may introduce additional noises to the system or
can cause severe damages due to electrostatic discharges.
129/133 Poznanska St., 05-850 Ozarow Mazowiecki, Poland; tel. +48 22 733 54 20; fax +48 22 733 54 26; e-mail:
8
Please note: the information contained in this document is subject to change without further notification. VIGO System reserves the right to alter the performance and any resulting specifications.VS-
11-08-10
MB
