str
12
ASSEMBLY
1. Before assembling or disassembling the appliance, make sure it is turned off and disconnected from the wall
outlet.
2. Attach the bottom pipe to the base with the supplied screw.
3. Extend the upper pipe, insert it through the connection into the lower pipe and tighten it.
4. Connect the motor part and the button compartment to the upper tube. Make sure the pipe is fully inserted,
then connect the parts with the supplied screw.
5. Unscrew the mounting nut from the engine cover.
6. Position the back protective grille firmly to the engine cover and then screw on the fixing nut by turning it
clockwise. Screw it firmly.
7. Push the fan onto the motor shaft and fasten it.
8. Attach the front grille to the back. The right placement is marked on the grids, connect them with the clamp.
OPERATION
Once the fan has been assembled and connected to the socket, select the rotational speed using the buttons.
Control button functions:
0 – Fan off
1 – Low air flow rate setting
2 – Setting the mean velocity of air flow
3 – High air flow rate setting
CONTROL OF HORIZONTAL OSCILATION (ROTATION TO SIDES)
1. For rotation of the fan to the sides at an angle of approx. 90°, push the switch on the motor unit down.
2. Pull it back upwards to end the rotation.
VERTICAL TILT ADJUSTMENT (TILT OF THE ENGINE UNIT)
Before setting the vertical angle of inclination of the motor unit, switch off the fan first. Set the required angle
of the engine unit and then you can start the fan again.
FAN HEIGHT ADJUSTMENT
The height of the fan can be set between 102 and 125 cm.
Turn the fan off before adjusting the height. With one hand firmly hold the outer pipe and release the lock with
the other hand by turning the locking nut counterclockwise. Slide or pull the internal pipe to adjust the fan
height. To lock the set height, tighten the nut clockwise.
CLEANING AND MAINTENANCE
Before cleaning, make sure the appliance is turned off and disconnected from the power outlet.
Remove the dust regularly with a clean, dry cloth. In case of greater dirt, disassemble the appliance and wipe the
parts with a damp cloth soaked in a warm water solution and a conventional detergent. Then dry thoroughly.
Ensure that water does not get into the motor unit or control panel when cleaning. Do not immerse the appliance
or its power cord in water or rinse it under running water.
Do not use steel wool, abrasive cleaners, gasoline and other aggressive thinners to clean.
STORAGING
If you do not use the fan for a long time, keep it in a clean, dry place, or remove it and put it back in the box.
Summary of Contents for 769-601
Page 24: ......