Warning:
You are cautioned that changes or modifications not
expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
Industry Canada ICES-003 Compliance: CAN ICES-3 (B)/NMB-3(B)
Contains FCC ID: PD98260NG
IC ID: 1000M-8260NG
Following information is only for EU-member states:
The mark shown to the right is in compliance with the Waste
Electrical and Electronic Equipment Directive 2012/19/EU
(WEEE).The mark indicates the requirement NOT to
dispose the equipment as unsorted municipal waste, but
use the return and collection systems according to local law.
Indian Restriction of Hazardous Substances
Restriction on Hazardous Substances statement (India) This product
complies with the “India E-waste Rule 2011” and prohibits use of lead,
mercury, hexavalent chromium, polybrominated biphenyls or polybromi-
nated diphenyl ethers in concentrations exceeding 0.1 weight % and
0.01 weight % for cadmium, except for the exemptions set in Schedule 2
of the Rule.
4
Compliance Information
NOTE
: This section addresses all connected requirements
and statements regarding regulations. Confirmed correspond-
ing applications shall refer to nameplate labels and relevant
markings on unit.
FCC Compliance Statement
This device complies with part 15 of FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
•
receiver.
• Connect the equipment into an outlet on a circuit different
•
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
•
for help.
CE Conformity for European Countries
The device complies with the EMC Directive 2014/30/EU,
Low Voltage Directive 2014/35/EU and
Radio Equipment Directive 2014/53/EU.
Summary of Contents for VPC12-WPO
Page 22: ...3 3 236 3 3 3 3 3 3 3 3 3...
Page 23: ...6 1 6 10 3 1 0 1 4 8 8 8 8...
